When an SU running a SW version lower than 5. In this case, an equivalent value of High will be automatically assigned to this parameter. This might occur together with unusually high values of Signal Width over microseconds. This is because higher the NF value in the AU will result in shorter coverage distance. Also, sometimes the retransmissions are performed only on the same modulation even if Retries on Lower Modulations are enabled and possible.
The presented distance may be higher than the real one. However, operation in near-line-of-sight or non-line-of-sight conditions can be achieved at shorter distances and certain favorable path propagation conditions; given link performance degradation is accepted.
This means that the entire spectrum is heavily interfered. In this case, it is recommended to decrease the Channel Scan Period and re-run Interference Mitigation. Page Installation Guidelines Installing the SU-I Subscriber Unit Installation Guidelines This section describes the installation guidelines and the various considerations that must be taken into account when planning the installation.
Location of the Unit The unit can be placed on a desktop or a shelf, or can be attached to a wall. A Monitor connector on the side panel for connecting an ASCII terminal with terminal emulation software for configuration and maintenance purposes. Page Figure Wall Mounting The Su-I These slots should be used to fasten cables coming out of the unit to the wall mounts, eliminating loose or tangled cable installations.
Page 55 To install the antenna and lightning protection: 1. Refer to Appendix B for instructions on installing the antenna. Page 56 2. Page Chapter 3 - Commissioning 3. Press Enter. The Select Access Level menu is displayed.
Select the required access level, depending on your specific access rights. A password entry request is displayed. Enter your password and press Enter. The Main Menu is displayed.
These parameters are: Hopping Set and Hopping Sequence parameters are not available. Refer to Appendix D Page Table Su-Ra The springy clip is facing down and parallel to the floor.
When looking down on the coppers, pin 1 is on the far left. Contact with high voltage lines is dangerous and can cause death or serious injury. Page 73 Verifying Proper Operation Mounting on a 2. Print page 1 Print document 84 pages. Enabling customers to get the best of both worlds, the VL will support both fixed and mobile applications allowing long range, high- capacity broadband for rural markets with near-NLOS and excellent propagation capabilities that are inherent to the MHz unlicensed band, but also take advantage of the high-power radio.
The new MHz version also includes hardware-based AES and an optional upgrade for FIPS as do all VL products to provide the secure encryption required for many applications without the dramatic reduction in capacity suffered by other software-based AES products. Actual max power may be limited for compliance with local regulation.
Multi-level password Configuration of remote direction from Ethernet only, wireless only, or both sides Configuration of IP addresses of authorized stations. DC output: 54V, 3. Metal box, vehicle mountable 5. ETS part class 3. Register Log In Home. By Manufacturer. By Category. Shopping Cart. My Account. About Us.
0コメント